User's Guide

92 Quantum|ATL PowerStor L500 Series Tape Library User’s Guide
ADH Fatal Timed-out leaving drive load position to
move to drive park position.
AEH Fatal Timed-out while moving a cartridge
back into a slot after error A4. This error
could only happen if the loader
controller tries to move a cartridge from
the slot onto the CHM and it fails. The
loader controller would then try to move
the cartridge back into the slot. If that
fails, this error is generated.
AFH Fatal Undefined error code.
B0H Fatal Undefined error code.
B1H Fatal Stand-alone mode.
B2H See
Description
Door open without getting a command.
After power up this command can occur
as the loader remembers the state of the
door.
This is an informational type error and
does not require recovery.
B3H See
Description
Unit was reset or powered up.
This is an informational type error and
does not require recovery.
B4H See
Description
Timed-out while prepositioning the
CHM during a prepositioning
command.
This command can be retried by issuing
a SCAN MAGAZINE command
followed by reissuing the
PREPOSITION command.
Error Code Error Type Description