User's Guide

FastStor 2 User’s Guide 55
D4H No RMU found Check the RMU connectivity and then power
cycle the unit. If the problem recurs, contact
your service representative (refer to Getting
Help on page 58).
D5H Error in write data to RMU EEPROM Check the RMU connectivity and then power
cycle the unit. If the problem recurs, contact
your service representative (refer to Getting
Help on page 58).
Table 19 Subcode Descriptions
Error Code Details and Description
00H No error.
01H Communication timeout.
02H Length expired before expected character got.
03H Any other kind of drive error.
10H Start pattern missing.
11H Sequence enumeration error.
12h Packet length error.
13H Checksum mismatch.
14H End pattern missing.
15H Drive busy -- command rejected.
16H General drive error.
17H Byte stuffing error.
18H Command negative acknowledged.
21H Carrier state error.
22H Repetitions error. Number of repetitions reached.
23H Move to slot position repetitions error. Number of repetitions at move to slot reached.
24H Move to eject position repetitions error. Number of repetitions at move to eject position
reached.
25H Belt start error. Start of belt motor unsuccessful.
26H Belt backward start error.Start of belt motor unsuccessful.
27H Belt home error. Home carrier at move to home position not found.
28H Unexpected belt home error. Unexpected home carrier detected at belt movement.
29H Belt door stop error. Belt stopped by door opening.
Table 18 Network Error Codes (Continued)
Error
Code
Description Details