User's Guide

50 Troubleshooting and Diagnostics
52H Parameter length error.
53H SCSI invalid opcode.
54H Invalid element address.
55H Invalid field in CDB.
56H Invalid mode on write buffer.
57H Invalid drive specified.
58H Invalid test number at diagnostic.
59H Invalid offset on write buffer.
5AH Invalid size on write buffer.
5BH Bad controller image checksum.
5CH Invalid LUN
5DH Parameter list error: invalid field.
5EH Parameter list error: parameter not supported.
5FH Parameter value invalid.
60H Saving parameters not supported.
61H Cleaning slot empty.
62H Cleaning slot doesn’t have cleaning tape.
63H SCSI invalid ID message.
64H Media load/eject failure.
65H Destination element full.
66H Source slot or drive empty.
67H Unrecognized loader command.
68H Wrong header length.
69H Bad sequence number.
6AH Wrong checksum.
6BH Command unspecified.
6CH Configuration problem: no bar code reader installed.
6DH Flash image does not fit boot code.
6EH Medium removal prevented by drive.
6FH Firmware image contains wrong personality.
Table 9 Illegal Request Error Codes (Continued)
Error Code Details and Description