User's Guide

46 Troubleshooting and Diagnostics
8 On each carrier, carefully pull the cartridge lock lever away from the carrier, allowing the cartridge to
slide out of the carrier.
9 After removing the cartridges from the desired carriers, reinstall each carrier on the autoloader belt.
• Make sure that the rollers on the bottom of the carrier are aligned in the carrier tracks.
• Make sure that the belt posts beneath each carrier are inserted into the proper autoloader belt
loop.
10 Ensure the carrier is properly installed on the belt by gently pressing on the top of the carrier and sliding
it back and forth. If it is properly attached to the belt, it should not move. If it does, reinstall the carrier.
11 Replace the top cover of the autoloader and reinstall the cover screws and mounting brackets.
NOTE:
There are unused loops on the belt. The proper belt loops have an extra
bump on the outside of the loop.