User's Guide

36 Using the Remote Management Unit
Resetting the Configuration
The following parameters can be reset:
Using the RMU Maintenance Pages
Only administrators and service personnel have access to the RMU Maintenance page. The following
parameters can be set by means of the Maintenance page:
• Operations
• General diagnostic
• Advanced diagnostic
•Firmware
• Reset
Running Operations
The Operations page allows users at the system administrator level to run the following predefined
operations:
• Reinitialize library controller
• Perform inventory scan
• Load cartridge into drive
• Unload cartridge from drive
• Import to slot
• Export from slot
• Perform clean process
• Perform drive upgrade
• Bulk exchange
These same operations can be selected by using the operator panel. Depending on the operation selected,
a slot number may also be required. All available slots are either enabled or disabled according to the
inventory status of the media. Click Execute to start the selected operation. There is no stop button to stop
the selected operation. Wait for the operation to complete and then check the status.
Running the General Diagnostic Test
The General Diagnostic page allows users at the system administrator level to run the system test. To run
system tests, select the number of test cycles and click Execute. To cancel a test before its normal
completion, click Stop.
SMTP server address IP address of the SMTP server used to send mail.
Label Description
Restore factory defaults Press Reset to restore the factory defaults. Power cycle the
unit after the reset is completed.