User's Guide

34 Using the Remote Management Unit
Configuring the Network
The following parameters can be configured for the network:
Configuring the User
The following parameters can be configured for the user:
Label Description
Loader SCSI ID Select the SCSI ID for the autoloader.
NOTE: This feature is not available for the LTO version of the FastStor 2.
Drive SCSI ID Select the SCSI ID for the drive.
Autoloader mode Select the mode for the autoloader. Refer to Autoloader Operating Modes
on page 22.
Barcode reader enabled Select Yes or No.
Label Description
DHCP address If DHCP mode is selected, the manual entries are disabled and are not used
Hostname Specify a hostname.
IP address Specify an IP Address in xxx.xxx.xxx.xxx format
Network Mask Specify a network mask in (xxx.xxx.xxx.xxx) format.
Gateway
Address
Specify the gateway address in (xxx.xxx.xxx.xxx) format.
NOTE:
After submitting the new information, you are asked to confirm the change.
Label Description
Access level There are three user account levels available in the system.
Access level name The name for each user account level can be changed. The
names entered here are used on the login screen. The currently
logged in user account level name is displayed at the bottom of
the left banner on each page
Password The password for each user account level can be changed. In
order to change the password for the selected password remove
the **** that are the default and type in a new password.
When changing the access level name, a new password has to
be entered for the new access level. It can be the old password
or a completely new one, but the password must be entered.
Repeat password This entry must match the previous entry.
OCP access pin enabled An optional operator panel access pin code is used to control
access to the operator panel.