Manualshelf

User's Guide

ManualsBrandsQuantum Manualscomputers & electronicsFastStor 2
31323334353637383940
FastStor 2 User’s Guide 31
Checking the Quick Status
A table containing an array of basic status information appears on the right side of the RMU display. This
Quick Status table appears on all RMU pages.The following pieces of information are displayed in the Quick
Status table:
Using the RMU Information Pages
These information pages display general information about the autoloader or the drive. These pages are
accessible by all user account levels. No changes can be made by the user.
The following pieces of information are reported for the autoloader:
NOTE:
The operator panel Configuration menu presents an option to reset, but not
an option to save.
Label Description
Name The name of the autoloader
Status The overall status of the autoloader by icon
Lock A lock to show the administrator is in the process of making
configuration changes. Valid values for "Loader Lock" are None, RMU,
SCSI, OCP and MONITOR. OCP is the term used for operator panel.
Cartridge in drive The slot number of the tape currently mounted in the tape drive
Drive Status Indicates by icon the overall status of the tape drive. The green "ok" icon
indicates that the autoloader is fully operational and that no user
intervention is required. The orange/yellow question mark indicates that
user intervention is necessary but that the autoloader is still operational.
The red cross indicates that user intervention is required and that the
autoloader is not operational
Drive Activity The current activity of the tape drive
Robotic Action The current activity of the autoloader’s robotics
Time The total amount of time the autoloader has been in operation
Drive Error Code The code of the last error that occurred. Clicking on this code takes the
user to a description of the code
Label Description
Serial number The serial number of the unit
Temperature The current operating temperature of the unit
Product ID FastStor 2.1
Controller firmware
revision
The version number of the robotics controller firmware
Firmware CRC The firmware’s cyclic redundancy check code