User's Guide

FastStor 2 User’s Guide 7
2 Remove the cover plate from barcode reader slot on the rear panel. Save the screws. Save and store
the cover plate; you may use this plate later after removing the barcode reader.
3 Orient the barcode reader before the slot. There is only one correct orientation. Check whether the holes
align.
4 Connect the cable to the barcode controller outlet.
5 Attach the barcode reader with the screws that you removed from the cover plate.
.
6 If you have installed the barcode reader into a previously installed and configured autoloader and you
want to restore power, power it on as follows. Otherwise continue to Choosing an Installation Location
on page 8.
a. Reconnect the SCSI cables to the rear panel of the autoloader.
b. Plug the power cord into the outlet.
c. Plug the power cord into the rear panel of the autoloader.
d. Use the tip of a pen to press the ON switch.
7 Check the LCD display to make sure the autoloader is receiving power. If it is not, check the power
connections and your power source. During the Power-On Self Test (POST), all four LEDs are
illuminated briefly, followed by just the Ready/Activity LED flashing. When the initialization sequence is
complete, the LCD screen displays the main menu.