User's Guide

6 Getting Started
5 Carefully remove the shipping padding from the left and right sides of the autoloader. Then remove the
bag from the autoloader.
Installing the Barcode Reader
Mount the barcode reader on the rear panel of the autoloader.
1 If you are installing the barcode reader into a previously installed and configured autoloader and the
autoloader power is on, power it off as follows:
a. Use the tip of a pen to press the OFF switch as shown below:
b. Unplug the power cord from the outlet.
c. Unplug the power cord from the rear panel of the autoloader.
d. Disconnect the SCSI cables from the rear panel of the autoloader.
NOTE:
Save the packing materials in case you need to move or ship the
autoloader in the future.
CAUTION:
To avoid electrostatic discharge damage to the unit, touch the
autoloader’s metal case or rear panel before installing the barcode
reader.
CAUTION:
Pressing the OFF switch stops the autoloader from functioning, but it
does not remove power from the autoloader. To remove power, you
must disconnect the power cord from the power source.