Instruction Manual

LAMP REPLACEMENT
Remove lamp bezel as shown below. Gently bend the snap at each side of
the collar to release the lamp
assembly.Unplug the connector from
the lamp assembly.
Route the lamp wires through one of
the center spaces under the new
lamp assembly, and replace it firmly
under the snaps on the collar,
making sure the wires are not
pinched. Plug the lamp connector
and replace the bezel
CHARGER BOARD REPLACEMENT
With the unit oriented as in the below
view, flex the channel outward to
release and remove it. Unplug the
battery, lamps, and other connections
at the left end of the charger board
Re-connect all components to the
new charger board, routing wires
as before. For insertion of PCB,
insert right side of PCB first,
followed by left side (click should
be heard).
Make sure all wires are routed as
before, so as not to interfere with
proper assembly of the housing
onto the mounting plate.
Reassemble the unit (see also step
5 and 6, page 3).
page 5
TESTING and MAINTENANCE (CONTINUED)
1
1
2
3
2
3
Connector
Release snaps gently
2
1
Collar
Collar button
Bezel
Carefully flex this
edge free from
collar button