Instruction Manual

FINAL ASSEMBLY
Connect battery and lamp plug to
charger board.
Install the plastic film to housing.
Connect AC input plug to charger
board.
Housing attachment to mounting
plate:
Make certain all wires and
connectors are routed to avoid
interference with other components.
Align latch openings on underside of
housing with latch buttons on
mounting plate. Firmly push housing
straight onto mounting plate, making
certain all four latches are fully
engaged, and the housing is closely
aligned to the mounting surface.
Federal Communications
Commission (FCC) Requirements:
This device complies with Part 15 of
the FCC Rules. This device may not
cause harmful interference.
WIRING DIAGRAM
Input Voltage
Pin
No.
Wire
color
Wire Label
120V-277V
1
Black
Hot 120V-277V
2
3
White
Neutral
120V-347V
1
Black
Hot 120V-347V
2
3
White
Neutral
Battery Type
Total Load
Nicad – 5S1P
5.04 W
Lamp
Battery
Status Indicator LED
Test Switch
Input from branch circuit. See label on wire
pair for voltage requirements.
Lamp
page 3
INSTALLATION and WIRING (CONTINUED)
4
6
5
Battery connector
Lamp connector
Plastic film
AC connector
PIN 1
PIN 3