User's Guide

Chapter 3 DX3000 and DX5000 Remote Management
Configuration
Quantum DX3000 and DX5000 User’s Guide 59
Table 8 Port Settings
Configuring the RAID Settings 3
The DX3000/DX5000 system allows you to remotely alter the RAID
configuration.
To access the RAID Configuration screen:
In the
Hardware page, click RAID.
The
RAID Configuration screen displays (see figure 38).
Field Description
Node World
Wide Name
(WWN)
The node WWN is the overall system
identification on the customer SAN. This field
allows you to set the WWN in case a controller
is replaced so the customer SAN will not
require remapping.
AL_PA and
Loop ID
This field allows you to set either a soft or hard
AL_PA. Soft allows the customer SAN to
automatically assign a loop ID to the DX3000/
DX5000 System. Hard allows you to manually
assign the loop ID. The Default setting is soft.
Speed
This field allows you to select the maximum
link speed of the Fibre Channel port (1GB/sec,
2GB/sec, or Automatic). The default setting is
Automatic.