User's Guide

Chapter 3 DX3000 and DX5000 Remote Management
Configuration
Quantum DX3000 and DX5000 User’s Guide 53
Figure 34 Device Mapping Page
2 There are four ways to assign virtual devices to a specific iSCSI or
Fibre Channel port:
•Click Auto Populate (partition per port) to allow the DX3000/
DX5000 controller to automatically assign virtual devices to a
port. The controller assigns a robot and partition to each port.
Example: A system with 1 partition would have a robot assigned
to LUN 0 and all other devices within that partition assigned to
additional LUNs on that port.
•Click Auto Populate (iSCSI only) to allow the DX3000/DX5000
controller to automatically assign virtual devices to ONLY the
iSCSI ports. The controller assigns a robot and partition to each
iSCSI port.
Example: A DX3000/DX5000 has two potential iSCSI ports. A
system with 2 partitions would have a robot assigned to LUN 0
on Eth 1 and Eth 2 and all other devices within that partition
assigned to additional LUNs on that port.