User's Guide

Chapter 3 DX3000 and DX5000 Remote Management
Configuration
Quantum DX3000 and DX5000 User’s Guide 43
4 Enter the alpha characters (0 to 6 characters) in the New Alpha Prefix
field.
5 Enter the numeric character in the Numeric Ending field.
6 When you have selected the tape(s) and both the alpha and numeric
characters, click
Apply.
Barcode labels are assigned for the selected tape(s).
7 Return the DX3000/DX5000 system to the on-line state (see
“Changing Library State” on page 84).
Configuring Library Properties 3
The library name identifies the DX3000/DX5000 system so it can be
distinguished from other devices on the network through the SNMP
interface.
To set the library name:
1 Set the DX3000/DX5000 system to the off-line state (see “Changing
Library State” on page 84).
2 From the Library link of the Configuration page, click the Properties
link.
The Properties page displays (see figure 27).
Note: If you are entering alpha characters for the first part of a
barcode number and this is the first number in a range, no
more than five characters can be used. This allows the
system to assign the last character in the field.
Note: This number is used as the first number in the range of
tape cartridges. The number will increment with each
additional cartridge in the field.