User's Guide

Chapter 3 DX-Series Remote Management
Remote Alerts
Quantum DX-Series User’s Guide 81
Table 26 SNMP Trap
Selections
3 Click Apply.
A Results page displays indicating the configuration has been
changed.
4 Click New in the Trap Destination area (see figure 54), to set the IP
addresses that are to receive the traps generated by the DX-Series
system,
for example, 12.34.56.78. Up to five trap destination
addresses may be set. If less than five trap destinations are required,
leave unused
Trap Destination fields blank.
Field Description
Informational
If selected,
Informational Traps are enabled.
Warning
If selected,
Warning Traps are enabled.
Failure
If selected,
Failure Traps are enabled.
Available
If selected, a trap is generated every time
the library transitions from an unavailable
to an available state.
Unavailable
If selected, a trap is generated every time
the library transitions from an available to
an unavailable state.