User's Guide

Chapter 3 Emulated DLT7000 SCSI Commands
Log Select (4Ch)
156 Quantum DX-Series Software Interface Guide
TMC Threshold Met Criteria. Once the criteria
specified in this field is met and the ETC bit is 1
and the RLEC bit in MODE SENSE / SELECT
Control Page is set to 1, then UNIT ATTENTION
is generated for all initiators.
The criteria for comparison are:
Code - Basis of Comparison
00b - Every update of the cumulative value
01b - Cumulative value equal to threshold value
10b - Cumulative value not equal to threshold
value
11b - Cumulative value greater than threshold
value
The Default Threshold Values are the maximum
values that each parameter can attain.
The Current Cumulative Values are the values
computed since the last reset of the device (either
via power-cycle, BUS DEVICE RESET, or SCSI
RESET).
The Default Cumulative Values are the values to
which each parameter is initialized at a reset
condition. Default values are zero.
By default, Current Threshold Values = Default
Threshold Values.
Note that all types of parameter values are
changeable via LOG SELECT.
LP List Parameter. This bit should always be set to 0
to indicate parameter codes are treated as data
counters.
Field Name Description