User's Manual

Configuring and Operating the DLT4500 Mini-Library
4-18 DLT4000/DLT4500/DLT4700 Cartridge Tape Subsytem
4.6.3 SCSI ID Select Mode
SCSI ID Select mode allows you to select the SCSI ID for the tape drive and to enter
Code Update mode. If you turn power off and then on again or reset the mini-library,
the SCSI ID you chose reappears after being stored.
Table 4-7 lists displayed messages during Firmware Update Mode operation.
Table 4-7 SCSI ID SELECT Mode Display Message
Display Message …… Tells you ……
SCSI ID SEL Mini-library is in SCSI ID Select mode
SCSI ID 0 SCSI ID is set to 0
SCSI ID 1 SCSI ID is set to 1
SCSI ID 2 SCSI ID is set to 2
SCSI ID 3 SCSI ID is set to 3
SCSI ID 4 SCSI ID is set to 4
SCSI ID 5 SCSI ID is set to 5
SCSI ID 6 SCSI ID is set to 6
SCSI ID 7 SCSI ID is set to 7
If you press the Select button while in SCSI ID Select mode, the stored SCSI ID you
chose moves by one increment. If you press the Select button when the stored SCSI ID
is 7, then the SCSI ID moves to 0.
Switch Functions
While in SCSI ID Select mode:
If you press and release the Display Mode button, the mini-library enters Normal
mode.