User's Manual

Configuring and Operating the DLT4500 Mini-Library
4-8 DLT4000/DLT4500/DLT4700 Cartridge Tape Subsytem
4.4.4 Connecting the SCSI Signal Cable to the Mini-Library
Examine the components on the mini-library rear panel (Figure 4-2) to complete the
physical installation.
To connect the SCSI signal cable:
1. Ensure the mini-library power is turned off.
2. Connect one end of the SCSI cable to an available SCSI signal connector on the
mini-library rear panel.
3. Snap the wire cable clamps into place or tighten the screws (whichever are
supplied) to secure the cable.
4. Connect the other end of the SCSI signal cable to the SCSI connector on your
system, or for daisy-chained configurations, to another SCSI device.
See your system documentation for system SCSI connections.