User's Manual

Configuring and Operating the DLT4000 Basic Tape Drive
3-20 DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem
3.7 Loading a Cartridge
The following are more detailed steps for loading a cartridge (Figure 3-8):
1. When the Operate Handle green indicator is on steady, lift the cartridge
insert/release handle open.
_________________________NOTE ____________________________
If Operate Handle indicator is blinking, close handle and wait for a steady
green indication, then lift handle and insert tape cartridge.
___________________________________________________________
2. Insert the cartridge.
3. Push the cartridge into the drive.
4. Push the handle closed.
_________________________NOTE ____________________________
To prevent handle failures, assist the handle to the closed position. Do not
flip it.
___________________________________________________________
The green indicator turns off and the yellow indicator blinks to show the tape is
loading. When the tape is at the BOT marker, the yellow indicator turns on steady.
The tape is now ready for use.