User's Manual

Configuring and Operating the DLT4000 Basic Tape Drive
3-2 DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem
3.2.1 Disabling Parity Checking
If your system does not generate parity, you can disable parity checking by adding a
jumper to the SCSI connector on the left side of the DLT4000 drive (Figure 3-1).
_________________________NOTE ____________________________
A jumper must always be placed on the Remote ID Present position
(Figure 3-2) for the host to recognize any ID selection on this connector
using jumpers. The default ID is factory set at 5.
___________________________________________________________