User's Manual

Technical Specifications
A-8 DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem
A.4 Identifying the Correct AC Power Cord
________________________ WARNING __________________________
Do not attempt to modify or use an external 100 - 115 VAC power
cord for 220 - 240 VAC input power. Modifying the power cord can
cause personal injury and severe equipment damage.
____________________________________________________________
An AC power cord was supplied with your unit. Carefully inspect it and make sure
that it is the correct one for your country or region based on the criteria listed below. If
you feel the supplied AC power cord is not correct, contact your authorized Quantum
service representative.
The AC power cord used with this equipment must meet the following criteria:
1. UL and CSA Certified cordage rated for use at 250 VAC with a current rating
that is at least 125% of the current rating of the product. In Europe, the cordage
must have the <HAR> mark.
2. The AC plug must be terminated in a grounding-type male plug designed for use
in your country. It must also have marks showing certification by an agency
acceptable in the country.
3. The connector at the product end must be an IEC type CEE-22 female connector.
4. The cord must be no longer than 14.5 feet (4.5 meters).
__________________________NOTE ____________________________
The power cord should be a minimum of 18/3 AWG, 60ºC, Type SJT
or SVT.
____________________________________________________________