User's Manual

DLT4000 SCSI Interface
DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem 8-65
Table 8-4 EEROM Vendor Unique Page Parameters
Name Value Rep. Default Length
(Bytes)
Usage
VENDORID ASCII QUANTUM 8 Vendor Identification field in Inquiry Data
PRODUCTID ASCII DLT4000 16 Product Identification field in Inquiry Data
FORCEDENSITY
2
ASCII Decimal 0 1
0=automatic
1
, 1=DLT260, 2=DLT600,
3=DLT2000xt, 4=DLT4000
FORCECOMP ASCII Binary 0 1
0=automatic
1
, 1=Always compress unless
front panel selection disables it
DEFAULTCOMPON ASCII Binary 1 1 0=Compression defaulted off on
powerup/reset,
1=Compression defaulted to on, on
powerup/reset
DEFFIXEDBLKLEN ASCII Decimal 0 8 Default fixed block size
ENBINQMEDCHGR ASCII Binary 0 1 0=disable media changer bit,
1=enable media changer bit in byte 6 of
inquiry data
LOADERLUN ASCII Decimal 1 1 1-7 = LUN to report media loader device
on
REWINDONRESET ASCII Binary 1 1 0=Do not rewind on Bus Reset or BDR
msg (Caution: May have partial block data
written to the tape, if reset happens during
writing.)
1=Rewind the media to BOT on reset.
ENALDRAUTOLD ASCII Binary 1 1 To turn on/off sequential loading with
loader.
DISLDRAUTOLDMC ASCII Binary 1 1
To partially disable sequential loading with
loader if any media loader command has
been received.
ENAPARERRRETRY ASCII Binary 0 1
To turn on/off parity error retry feature.
ENAMODEPG22 ASCII Binary 0 1
To enable vendor unique Data
Compression (Status Mode Page).
1
Parameter is not forced to a special format, which is decided by the parameters
selected in MODE SELECT.
2
Applied to DLTtape III tape for DLT260 format, DLT600 format and DLT2000xt
format. Applied to DLTtape IV tape for DLT4000 format