User's Manual

Firmware Update (From Tape)
DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem 7-11
7.4.2.1 Interpreting the Results (DLT4500 Code Update)
The following results can occur:
Table 7-2 Results (DLT4500) Code Update)
If …… This means …… And you should ……
The code update
cartridge unloads from
the drive and loads into
the magazine slot from
which it came
The update succeeded.
The controller's flash
EEPROM memory is
updated with the new
firmware image.
Begin operating the
mini-library.
The code update
cartridge does NOT
unload from the drive
and load into the
magazine.
The update failed. The
drive may reset and the
ERR UNK message may
display. The mini-
library should still be
usable, but this depends
on why the update
failed. The reasons for
failure could be: