User's Manual

Configuring and Operating the DLT4700 Mini-Library
DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem 5-3
5.3.1 Configuration Guidelines
The system uses the SCSI ID to identify, or address, the DLT4700 mini-library.
Follow these guidelines when configuring the DLT4700 mini-library for your system:
If you install the DLT4700 as …… Then ……
The only SCSI device or one of
multiple SCSI devices on the bus
Be sure to use a SCSI ID that is unique
from any other device or system ID on
the SCSI bus.
The last or only device on the
SCSI bus
You must terminate the bus by installing
a terminator.
5.3.2 Disable Parity Checking
To disable parity, see your service representative.
5.3.3 Change the SCSI ID
Change the SCSI ID via the pushbutton switch on the mini-library rear panel. Press
the switch button(s) above or below the number display (0-7) to set the desired SCSI
ID. Press the top button to increase the number or press the bottom button to decrease
the number.