User's Manual

Configuring and Operating the DLT4700 Mini-Library
5-2 DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem
Auto-loading is implemented as a side effect of the SCSI UNLOAD command.
If …… And …… Then ……
An unload is
specified
A media loader is
present
After winding the tape back into
the cartridge and moving the
cartridge from the drive to the
magazine slot from which it
came, the cartridge in the next
slot is moved from the magazine
into the drive and made ready.
The next slot is
empty, or the
cartridge unloaded
was for the last slot
in the magazine
No cartridge is loaded into the
drive.
5.3 Configure the DLT4700 Mini-Library
This section describes how to configure the DLT4700 mini-library including:
Topic Section
Configuration Guidelines 5.3.1
Disable Parity Checking 5.3.2
Change the SCSI ID 5.3.3
The DLT4700 mini-library is factory set to SCSI ID 5, unless otherwise specified.
If your system generates parity, the DLT4700 mini-library can check for correct parity
on the SCSI bus.