User's Manual

Configuring and Operating the DLT2700 Mini-Library
5-2 DLT2000/DLT2500/DLT2700 Cartridge Tape Subsystem
Auto-loading is implemented as a side effect of the SCSI UNLOAD command.
If …
……
… And …
……
… Then …
……
…
An unload is
specified
A media loader is
present
After winding the tape back into the
cartridge and moving the cartridge
from the drive to the magazine slot
from which it came, the cartridge in
the next slot is moved from the
magazine into the drive and made
ready.
The next slot is
empty, or
the cartridge
unloaded was
for the last slot in
the magazine
No cartridge is loaded into the drive.
5.3 Configure the DLT2700
This section describes how to configure the DLT2700 including:
Topic Section
Configuration Guidelines 5.3.1
Switchpack Location 5.3.2
Disable Parity Checking 5.3.2
Change the SCSI ID 5.3.3
The DLT2700 is factory set to SCSI ID5, unless otherwise specified.
If your system generates parity, the DLT2700 can check for correct parity on the SCSI
bus.