User's Manual

Installing and Configuring the DLT2000 Tabletop Drive
DLT2000/DLT2500/DLT2700 Cartridge Tape Subsystem 2-5
2.4.2 Disable Parity Checking
To disable parity, see your service representative.
2.4.3 Changing the SCSI ID
To change the SCSI ID use the pushbutton switch on the rear of the drive. Press the
switch button(s) above or below the number display (0-7) to set the desired SCSI ID.
Press the top button to increase the number or press the bottom button to decrease the
number.
MLO-012870
0
0
Figure 2-2 Changing the SCSI ID via the Pushbutton Switch
2.5 Connect the Cables
Section 2.5 includes the following topics:
Topic Section
Examine the DLT2000 Rear Panel 2.5.1
Connect the SCSI Signal Cable 2.5.2
Terminate the SCSI Bus 2.5.3
Connect the Power Cord 2.5.4