User's Manual

Configuring and Operating the DLT2700 Mini-Library
DLT2000/DLT2500/DLT2700 Cartridge Tape Subsystem 5-3
5.3.1 Configuration Guidelines
Your system uses the SCSI ID to identify, or address, the DLT2700. Follow these
guidelines when configuring the DLT2700 for your system:
If you install the DLT2700 as …
……
… Then …
……
…
The only SCSI device or one of
multiple SCSI devices on the bus
Be sure to use a SCSI ID that is unique
from any other device or system ID on the
SCSI bus.
The last or only device on the SCSI
bus
The user must terminate the bus by
installing a terminator.
5.3.2 Disable Parity Checking
To disable parity, see your service representative.
5.3.3 Change the SCSI ID
The user can change the SCSI ID via the pushbutton switch on the mini-library rear
panel. Press the switch button(s) above or below the number display (0-7) to set the
desired SCSI ID. Press the top button to increase the number or press the bottom button
to decrease the number.