User's Manual

Chapter 1 Physical Specifications
Internal Tape Drive Mounting Hole Dimensions
DLT-V4 Product Specification 6
Figure 2 Mounting Hole
Dimensions (Side View)
Notes:
The following is additional information for figure 2.
• The dimension referenced in boxed note [1] is from the front of the base plate.
• The dimension referenced in boxed note [2] is from the bottom tape drive mounting plane to the
interior guiding surface of the media opening.
• Boxed note [3] states that the data cartridge is shown in the ejected position.
• The tape drive width and length are standard 5¼-inch form factor measurements.
• Dimensions are identical on left side and right sides.
• Dimensions are in millimeters. The dimensions in brackets [x.x] are in inches.
Data cartridge