User's Manual

Chapter 1 Physical Specifications
Internal Tape Drive Mounting Hole Dimensions
DLT-V4 Product Specification 5
Figure 1 Internal Tape Drive
Mounting Hole Dimensions
(Bottom View)
Figure 2 shows the mounting holes and dimensions in a side view for the
internal tape drive.
Notes: The following is additional information for figure 1.
• The dimension referenced in boxed note [1] is from the front of the base plate.
• The dimension referenced in boxed note [2] is from the right-side tape drive mounting plane to the
interior guiding surface of the media opening.
• The dimension referenced in boxed note [3] is from the bottom tape drive mounting hole to the
interior guiding surface of the media opening.
• The tape drive width and length are standard 5¼-inch form factor measurements.
• Dimensions are identical on left side and right sides.
• Dimensions are in millimeters. The dimensions in brackets [x.x] are in inches.
Data cartridge