User's Manual

Chapter 7 Installing the Device Drivers
Microsoft Windows 2000
DLT-V4 Product Manual 50
c
In Device Manager, the DLT-V4 tape drive will be listed under
either “Tape drives” or “Other devices”. Locate the entry for the
DLT-V4 tape drive. Then double-click that entry to display the
Drive Properties.
d Click the Driver tab. Then click Update Driver ....
e The “Upgrade Device Driver Wizard” will start. Proceed with
step 4
.
4 In the “Upgrade Device Driver Wizard”, click Next to continue.
5 Select the radio button labeled “Display a list of the known drivers
for this device so that I can choose a specific driver”. Then click
Next.
6 If the drive is unknown to the system, the next view is “Hardware
Type”. Otherwise, the “Select a Device Driver” view is displayed.
a If the “Hardware Type” view appears, select either “Other
devices” or “Tape drives”. Then click
Next to continue on to the
“Select a Device Driver” view.
b In the “Select a Device Driver” view, click Have Disk ....
7 At the “Install From Disk” view, click Browse ..., and then locate the
folder where you saved the driver files. Select the “QntmDLT.inf” file
in that folder, and click
Open.
8 At the “Install From Disk” view, verify that the drive letter and path
shown are correct. Then click
OK.
9 In the next view, highlight the Quantum DLT-V4 tape drive, and then
click
Next. The “Start Device Driver Installation” view is displayed.
10 Click Next to install the driver.
11 The next view is “Completing the Upgrade Device Driver Wizard”.
Click
Finish. You may be prompted to reboot your system.
The DLT-V4 device driver is installed.
Note: If the Wizard should indicate that a driver already exists
on the system and prompts you for a selection, select
New.
When the Windows 2000 Setup window is displayed,
verify the correct path to the driver, and then click
Continue.