User's Manual

Chapter 5 Installing the Tabletop SCSI Tape Drive
Terminating the SCSI Tabletop Tape Drive
DLT-V4 Product Manual 41
Powering the Terminator 5 At least one device on the SCSI bus must supply terminator power
(
TERMPWR). The factory default for the tape drive is for TERMPWR to be
enabled. Only an authorized service provider can disable the tape drive
TERMPWR setting. Attach the terminator as shown in figure 22.
Figure 22 Tabletop SCSI Tape
Drive Rear Panel Connections
Note: It is acceptable for more than one device on the SCSI bus to
provide
TERMPWR.
Terminator
(or cable to
next SCSI
device)
Power cord
SCSI cable
(to computer or
previous SCSI
device)