User's Manual

Chapter 4 Installing the Internal SATA-to-USB Tape Drive
USB Requirements
DLT-V4 Product Manual 24
USB Requirements 4
The tape drive must be connected to a USB 2.0 port.
Installation Steps 4
To install the tape drive, perform the following tasks in this order. Follow
the detailed instructions on the pages listed below.
Table 4 Installing the DLT-V4
Internal SATA-to-USB Tape
Drive
Step Instruction Page
1 Unpack and check the tape drive for shipping
damage.
Page 25
2 Select a server or workstation that is to host
the tape drive.
Page 25
3 Download and install the current device
driver (if required) (see chapter 7, Installing
the Device Drivers).
Page 48
4 Install the tape drive in the server or
workstation. Connect the power and data
cables to the tape drive.
Page 25
5 Connect the SATA data cable to the SATA-to-
USB adapter. Connect the SATA-to-USB
adapter to the host PC motherboard or USB
HBA.
Page 28
6 Complete the installation by securing the tape
drive in the host server or workstation and
turning on power.
Page 30
7 Confirm the installation. Page 32