User's Manual

DLT-V4 Product Manual 23
Chapter 4
4Installing the Internal
SATA-to-USB Tape Drive
This chapter contains step-by-step instructions for installing the DLT-V4
internal SATA tape drive with USB adapter.
The internal SATA-to-USB tape drive attaches to the server through a
USB adapter. The SATA-to-USB tape drive is the same as the SATA tape
drive but uses a special SATA-to-USB adapter to connect to the USB port
on your PC’s motherboard or host bus adapter.
Equipment Required 4
To install the DLT-V4 internal SATA-to-USB tape drive, you need a
PHILLIPS® screwdriver and adequate ESD protection.
You also need the SATA-to-USB adapter (provided in your accessories
kit) in order to install the tape drive correctly. The adapter kit is also
available at
www.quantum.com (part name: Quantum USB 2.0 to SATA
Direct-Connect Motherboard Adapter; part number: CNU-UA1100MA).