User's Guide

Commands: Read Block Limits (05h) Page 111
Completion Status
The Completion Status for the READ BLOCK LIMITS command is shown in the
following table.
Code Message Description
00h Good
Status
• The drive is ready to perform any appropriate command.
• The drive remains in any previously set mode.
• The tape position is not changed.
02h Check
Condition
Extended Sense Byte 02h:
Code Message Description
02h Not Ready No cartridge is inserted in the drive.
04h Hardware Error Drive hardware failure detected.
05h Illegal Request The CDB or Parameter List contains an
invalid bit.
06h Unit
• Cartridge was changed prior to accepting
Attention this command
• The drive was reset prior to this command.