Specifications

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-04, Ver. 4, Rel. 0
February 2002
Installing the Bottom Mounting Tray Assembly 9
Installing the Bottom Mounting Tray Assembly 0
To install the bottom mounting tray assembly in the rack:
1 Remove the six screws and washers securing the rear support arms
to the sides of the bottom mounting tray (see figure 5
).
Figure 5 Adjusting the
Depth of the Bottom
Mounting Tray Assembly
2 Adjust the position of the rear support arms on the bottom
mounting tray until the distance between the front and rear flanges
is approximately the same as the distance between the front and
rear mounting strips in the rack.
3 Replace the six screws and washers you removed in step 1 and
finger-tighten them. Position the front and rear screws as far apart
as the slots allow. Position the third screw approximately in the
middle slot.
4 Position the bottom mounting tray assembly in the rack, referring
to figure 6
for the correct orientation.
Note: Do not over-tighten the screws. You need to be able to
extend or retract the rear support arms slightly as you
install the bottom mounting tray assembly.
Note: Position the front and rear flanges on the bottom
mounting tray outside of the rack rails.