Specifications

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-04, Ver. 4, Rel. 0
February 2002
8 Installing the Top Mounting Tray Assembly
3 Replace the six screws and washers you removed in step 1 and
finger-tighten them. Position the front and rear screws as far apart
as the slots allow. Position the third screw approximately in the
middle slot.
4 Position the top mounting tray assembly in the rack, referring to
figure 4
for the correct orientation.
Figure 4 Securing the Top
Mounting Tray Assembly to
the Rack
5 Secure the top mounting tray assembly to the rack, using eight
screws (YS42011) and washers (YS40404) provided in the StackLink
kit (see figure 4
).
6 Fully tighten the six screws and washers securing the rear support
arms to the sides of the top mounting tray.
Note: Do not over-tighten the screws. You need to be able to
extend or retract the rear support arms slightly as you
install the top mounting tray assembly.
Note: Position the front and rear flanges on the top mounting
tray outside of the rack rails.
Note: If the rack has widely spaced mounting holes, it may not
be possible to use all four screws to secure the rear
flanges. If this is the case, one screw per side at the rear is
acceptable.
FRONT
REAR