Specifications

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-04, Ver. 4, Rel. 0
February 2002
Installing the Top Mounting Tray Assembly 7
Figure 2 Inserting Caged
Nuts into the Rack Rails
Installing the Top Mounting Tray Assembly 0
To install the top mounting tray assembly in the rack:
1 Remove the six screws and washers securing the rear support arms
to the sides of the top mounting tray (see figure 3
).
Figure 3 Adjusting the
Depth of the Top Mounting
Tray Assembly
2 Adjust the position of the rear support arms on the top mounting
tray until the distance between the front and rear flanges is
approximately the same as the distance between the front and rear
mounting strips in the rack.
Caged nuts
Flat blade
screwdriver