Specifications

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-04, Ver. 4, Rel. 0
February 2002
18 Installing the Safety Blanking Panels
Installing the Safety Blanking Panels 0
To avoid personal injury or damage to the StackLink mechanism,
install safety blanking panels over all empty locations in the M1500
stack.
1 If the holes in the rack rails are square (untapped), insert caged
nuts into the holes where the front safety blanking panels will be
installed.
2 Install front safety blanking panels (212579) at the front of the rack,
securing each panel with two screws (YS42011) and washers
(YS40404).
3 Install rear safety blanking panels (212502) at the rear of the rack,
securing each panel with two screws (YS41964).
Cabling the Library 0
The library cabling procedure consists of the following steps:
• Interlibrary (control bus) cabling
• StackLink motor connection
• SCSI bus cabling
• Power cabling
Interlibrary (Control
Bus) Cabling
0
The intelligent control bus allows the individual libraries in the rack to
communicate. To connect this bus:
1 Connect the top M1500 module in the rack to the terminator on the
front of the motor assembly, using one of the library control bus
cables provided (PN AS3642).
2 Daisy chain the control bus as shown in figure 15, using the library
control bus cables provided (PN AS3642).