Specifications

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-04, Ver. 4, Rel. 0
February 2002
16 Installing the Libraries
Installing the Libraries 0
Now that the StackLink is installed in the rack, install the libraries as
follows:
1 If you have not done so already:
a Unpack and install the rack mount shelves on which the M1500
libraries will be placed, referring to the Quantum|ATL M1500
Universal Rack Mount Kit Installation Instructions (PN 6421004).
b Unpack the M1500 libraries, referring to the Quantum|ATL
M1500 Library Unpacking Instructions (PN 6421002).
2 Install an M1500 library in the top StackLink position.
a Verify that the rack mount shelves are level and securely
fastened to the rack.
b With the help of another person, lift the library onto the rack
mount shelves.
c Slide the library all the way into the rack.
d Press the white button next to the left magazine access door
and open the door.
Note: The libraries will be installed from the top of the rack
downward; position the rack mount shelves accordingly.
For example, if you were installing two libraries in a
5-high StackLink, you would install two sets of rack
mount shelves: one set 4U below the StackLink top
mounting tray assembly, and another set 8U below the
StackLink top mounting tray assembly.
Caution: Make sure to remove the StackLink cover plate from
the rear of the libraries.
Caution: When sliding the library into the rack, be very careful
not to abrade or disconnect the ribbon cable that
connects the vertical shuttle assembly to the control
board on the motor assembly. See figure 12
for the
location of this cable.