Specifications

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-04, Ver. 4, Rel. 0
February 2002
Attaching the Shuttle Assembly to the Top and Bottom Mounting Tray Assemblies 15
Attaching the Shuttle Assembly to the Top and Bottom
Mounting Tray Assemblies
0
To attach the shuttle assembly to the top and bottom mounting tray
assemblies:
1 At the rear of the rack, lift the shuttle assembly and position it so
the carriage faces forward into the rack.
2 Rest the lower end of the shuttle assembly on top of the bottom
mounting tray assembly.
3 Ensure that the motor at the top of the shuttle assembly is aligned
with the cutout in the top mounting tray assembly.
4 Slide the shuttle assembly fully into the rack.
5 Secure the shuttle assembly to the upper and lower mounting trays
using six screws (YS41952) and washers (YS40402) provided in the
StackLink kit (see figure 13
).
Figure 13 Installing the
Shuttle Assembly
Note: Tighten these screw to finger-tightness only. You will
finish securing the StackLink after you have installed
libraries in the rack.
(SHOWN OUTSIDE OF RACK)
FRONT
REAR