Specifications

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-04, Ver. 4, Rel. 0
February 2002
14 Installing the Motor Assembly
Figure 11 Routing the Belt
4 Connect the ribbon cable from the vertical shuttle assembly to the
socket on the control board at the rear of the motor assembly as
shown in figure 12
:
a Route the ribbon cable behind the motor plate.
b Insert the ribbon cable connector through the rectangular hole
at the top of the motor plate.
c Connect the ribbon cable connector to the socket on the control
board.
Figure 12 Connecting the
Ribbon Cable
Ribbon cable
Motor plate
Rectangular hole