Specifications

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-04, Ver. 4, Rel. 0
February 2002
Installing the Carriage/counterweight Assembly 11
Figure 7 Installing the
Carriage/counterweight
Assembly
2 Route the belt connecting the counterweight and carriage up and
over the top of the vertical shuttle assembly, making sure not to
twist the belt.
3 Slide the carriage onto the top of the vertical shuttle assembly,
engaging the guide wheels of the carriage with the vertical rails.
4 Secure the umbilical cable to the underside of the carriage (see
figure 8
):
a Locate the pin on the underside of the carriage.
b Slide the umbilical cable underneath the open end of the pin.
c Rotate the pin until the umbilical cable is held snugly.
d Tighten the screw to secure the pin.
5 Snap the end of the umbilical chain onto the bottom of the carriage
(see figure 8
).
Carriage
Counterweight
Belt
Shuttle extrusion