Specifications

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-04, Ver. 4, Rel. 0
February 2002
10 Installing the Carriage/counterweight Assembly
Figure 6 Securing the
Bottom Mounting Tray
Assembly to the Rack
5 Secure the bottom mounting tray assembly to the rack, using eight
screws (YS42011) and washers (YS40404) provided in the StackLink
kit (see figure 6
).
6 Fully tighten the six screws and washers securing the rear support
arms to the sides of the bottom mounting tray.
Installing the Carriage/counterweight Assembly 0
Now that the top and bottom mounting tray assemblies are installed,
install the carriage/counterweight assembly on the vertical shuttle
assembly (see figure 7
):
1 Slide the counterweight onto the bottom of the vertical shuttle
assembly, engaging the guide wheels of the counterweight with the
vertical rails.
Note: If the rack has widely spaced mounting holes, it may not
be possible to use all four screws to secure the rear
flanges. If this is the case, one screw per side at the rear is
acceptable.
FRONT
REAR