User's Manual

AMASS Overview
6-00026-01 Rev A Online Archiving with AMASS 1-19
ADIC Scalar 1000
AMASS does not support automatic drive cleaning on the
ADIC Scalar 1000 with firmware earlier than level 2.10.
Consequently, the Cleaning Mode must be disabled as follows:
Step 1. Enter the Main menu by pressing the Escape
button on the operator panel.
Step 2. Scroll the Main menu using the navigation buttons
or . Select the Setup menu by pressing
Enter .
Step 3. Scroll the Setup menu using the navigation buttons,
and select the Cleaning menu by pressing Enter.
Step 4. Scroll the Cleaning menu using the navigation
buttons, and select the Drives dialog box by pressing
Enter.
Step 5. See if the first line in the box shows that automatic
drive cleaning is disabled, “Auto Clean: N”, if so
then no further action is required. Press the Escape
button until you reach the Status Display menu (the
initial screen).
However, if the first line shows that automatic drive
cleaning is enabled, “Auto Clean: Y”, change the Y
to an N with the navigation buttons.
Step 6. Move to the “ACCEPT:N” part of the screen by
pressing Enter, and change the N to a Y with the
navigation buttons.
Step 7. Save the changed cleaning state by pressing Enter.