User`s guide

1. Connect the interface cable supplied with your printer as shown above

2. Connect the other end of the cable to the corresponding port of your computer

3. Connect the supply cable to the supply and then connect the connector of the sup-

ply cable to the printer

4. Then connect the end of the supply cable to an earthed mains socket

5. Turn on the printer as follows :

The green LED’s from the control panel lights and the print head rises and falls,

indicating that the mechanical operation of the printer is correct.

If the green LED’s fails to light, this means that the installation has not been car-

ried out correctly or even that the operation of the printer is faulty. Check the

installation.

IMPORTANT !

This product is turned off by disconnecting it from the mains, which must remain

accessible.

This product must be connected to an electrical installation that is correctly pro-

tected and earthed

5. Installing the ribbon

1. Open the printer cover by pressing the cover lever, then pivoting it.

IMPORTANT !

2. Install the ribbon in the printer as indi-

cated and then close the printer cover.