User`s guide

A command sequence must be sent via the printer interface to insert a card in the prin-
ter and then place it under the station and establish contact.
The sequence of commands is described as follows :
Sending the Sis sequence :A card is moved from the feeder to the Contact Station and
stops under it.
The card is pushed up to come into contact with the station.
The printer links the contact post with the DB-9 connector.
The chip may be programmed via the series interface of
the computer and the external coupling.
NOTE !
See the programming guide of the Quantum printer to obtain more complete
information concerning the programming.
49
DDBB--99 ccoonnnneeccttoorr ppiinnss CCaarrdd ttoo cchhiipp ccoonnttaacctt ppooiinnttss
11 CC11 ((VV cc..cc..))
22 CC22 ((rreesseett ttoo 00))
33 CC33 ((CClloocckk))
44 CC44 ((rreesseerrvveedd))
55 CC55 ((mmaassss))
66 CC66 ((VVpppp))
77 CC77 ((EE--SS))
88 CC88 ((rreesseerrvveedd))
99 CC99 MMaassss wwhheenn tthhee cchhiipp iiss sswwiittcchheedd
wwiitthh tthhee ccoonnttaacctt ppoosstt