User`s guide

These LED’s indicate :
The LED’s on the control panel are represented in one of the following states :
The push button allows re-initialisation in case of :
■ No card in feeder 1 or feeder 2
■ Internal printer problem
The push button also enables :
■ a test card to be printed (see point 2 of this section)
■ a cleaning cycle to be launched (see point 1 of section 3)
Consult the following conditions of the control panel to determine the activity of the
Quantum printer or the nature of the problem :
28
PRINTER READY
DATA TREATMENT
END OF RIBBON
ABSENCE OF CARD IN
THE FEEDER/S
The printer is ready to receive data
The printer is receiving data from one or seve-
ral of its interfaces
■ there is no ribbon in the printer
■ the ribbon has finished
■ the ribbon has been uncorrectly installed in
the printer
Check the status of the ribbon in the printer. If you
have a printing job in course, this starts again with
a new card
■ there is no card in the feeder/s
Empty the hopper/s and then press the push
button for one second. The printing starts
again
Status of the LED’s Interpretation Solution or explanation