User`s guide

Take a cleaning card and place it in feeder 1.

4. Press the push button from the control

panel for a few seconds. The cleaning

starts.

5. After a few seconds, the printer cleaning is per-

formed and the used card is ejected into the reject

box 1.

IMPORTANT !

After performing a cleaning cycle, wait 2 minutes for the cleaning fluid to eva-

porate completely before using the printer again.

NOTE!

It is also possible to start a cleaning sequence without waiting for the cleaning

signal of the printer. This action is carried out by pressing the push button from

the Control Panel for few seconds. In this case, repeat operations 1, 2 and 3

above.

Although the cleaning signal has been activated, the printer will continue to work.