Operator's Guide

Chapter 2 Operating the Library
Using the Control Panel Menus
32 Quantum|ATL 7100 Series Library Operator’s Guide
Table 3 Tape Drive
Locations
7 With the proper drive number displayed on line 2, press the
SELECT button and verify the following is displayed in the
SDA:
8 Use the ↑ and ↓ buttons to navigate to the SCSI ID for the
selected drive.
9 With the proper SCSI ID displayed on line 2, press SELECT.
10 Exit the menu mode.
11 After changing the SCSI address of the drives, do one of the
following to set the new SCSI ID:
• Run the Reset Drives command from the Diagnostic
Software Package.
• Issue a “SCSI Bus Reset” from the host controller.
• Power the library off and on again.
Tape Drive Number Physical Location
Drive 0 top drive
Drive 1 second drive
Drive 2 third drive
Drive 3 fourth drive
Drive 4 fifth drive
Drive 5 sixth drive
Drive 6 bottom drive
Menu:Drive 0
SCSI ID 0
Caution:
If you turn the library power off and then on
again, be sure to leave the power off for at least
15 seconds before turning power back on.